9
Step 2
Connect the Sensor Cable I (24) from the Base Frame (34) to the Sensor Cable II (25)
from the Right Handlebar Support Tube (35R). Then install the Right and Left Handlebar
Support Tubes (35R, 35L) to the Base Frame (34) by inserting the Right and Left
Handlebar Support Tubes (35R, 35L) into the Base Frame (34), using six M8x15mm. Bolts
(56), six Ø8.1xØ12.3xt2.1 Spring Washers (73), four Ø8.4xØ16xt1.6 Curve Washers (76),
and two Ø8.4xØ16xt1.6 Washers (75). Tighten bolts with the M5 Allen Wrench with
Phillips Screwdriver Provided.
NOTE:
Do not fully tighten hardware in step 2 until step 3 is completed.
IMPORTANT:
While sliding the right handlebar support tube into the base frame, make
sure the cables are installed inside the handlebar support tube and pay attention not to
pinch the cables.
Hardware:
35R
35L
25
56
76
73
56
73
75
24
34
M5 Allen Wrench with
Phillips Screwdriver
Tool:
6 Bolts (M8x15mm.)
6 Spring Washers
(Ø8.1xØ12.3xt2.1)
2 Washers
(Ø8.4xØ16xt1.6)
4 Curve Washers
(Ø8.4xØ16xt1.6)