6.
Locate a BOTTOM HANDRAIL SPACER (#8). Insert the BOTTOM
HANDRAIL SPACER between the bottom of the HANDRAIL (#4)
and the FRAME (B) with the long taper facing the front of the unit as
shown. Align the two mounting holes in the HANDRAIL, BOTTOM
HANDRAIL SPACER, and FRAME and insert two LONG
MOUNTING BOLTS (#7) and tighten securely using a 5/32” hex key
wrench.
7.
After securing the USER RIGHT SIDE HANDRAIL (#4 or #11) to
the USER RIGHT UPRIGHT (#2), remove the USER LEFT
UPRIGHT rear mounting bolt and carefully twist THE USER LEFT
UPRIGHT (#1) outward until the rear mounting flange is off of the
FRAME (B).
NOTE: BE CAREFUL NOT TO TILT THE USER LEFT
UPRIGHT (#1) FROM UNDER THE DISPLAY CONSOLE (#3)
WHEN TWISTING THE USER LEFT UPRIGHT OUTWARD.
Reach a finger up into the ACCESS HOLE (E) located under the
USER LEFT UPRIGHT mounting flange and guide the 10-PIN
CONNECTOR (10P) of the WIRE HARNESS (C) that was fed into
the USER LEFT UPRIGHT through the BOTTOM CABLE
ROUTING HOLE (F) of the USER LEFT UPRIGHT. Carefully pull
the excess wire from within the USER LEFT UPRIGHT. Plug the 10-
PIN CONNECTOR into the CONTROL BOARD (G) located in the
MOTOR COMPARTMENT (H). Feed any excess wire back into the
USER LEFT UPRIGHT.
NOTE: BE CAREFUL NOT TO DAMAGE THE WIRE
HARNESS (C) WHEN PULLING IT THROUGH THE BOTTOM
CABLE ROUTING HOLE (F) IN THE USER LEFT UPRIGHT (#1).
8.
Carefully twist the USER LEFT UPRIGHT back into position on the
FRAME (B) and re-insert the rear MOUNTING BOLT (#10). Tighten
the BOLT using a 9/16” combination wrench until snug and then
back it off 1/4 turn.
NOTE: BE CAREFUL NOT TO DAMAGE THE WIRE
HARNESS (C) WHEN TWISTING THE USER LEFT
UPRIGHT (#1) BACK INTO POSITION.
9.
Repeat
Step 4
for Models T3 and T5 or
Steps 5 and 6
for Models
T3i and T5i to assemble the USER RIGHT HANDRAIL.
For Models T3I and T5I, tighten all five mounting bolts and then back
them off one full turn.
4
7
8
B
1
D
3
B
C
F
10P
1
E
B
C
1
10P
G
H
E
