7
• Slide one ACCORDION SLEEVE (24) and two PILLOW BLOCKS (17) over the PIVOT ARM (4) as shown in FIGURE 4
STEP 4
FIGURE 4
•
SECURELY
assemble the PIVOT ARM (4) to the CROSS SUPPORT (3) using four previously inserted 3/8 X 3” BUTTON
HEAD CAP SCREWS (13), four RH WASHERS (16), four 3/8” SAE WASHERS (15), four 3/8” LOW HEIGHT LOCK NUTS
(14) and four RH CAPS (33) as shown in FIGURE 5.
STEP 5
:
FIGURE 5
24
17
4
TIGHTEN!
SET SCREWS
•
IMPORTANT!
When PIVOT ARM (4) is centered and level in the PILLOW BLOCKS (17), tighten the PILLOW BLOCK set
screws.
13 3/8 X 3” BUTTON HEAD
4
3
33
15
16
14
22
• Assemble one RUBBER BUMPER (22) to the CROSS SUPPORT (3) where the PIVOT ARM (4) shaft contacts tube.
32
13 3/8 X 3”
BUTTON HEAD
• Assemble four 3/8 X 3” BUTTON HEAD CAP SCREWS (13) and four STARLOCK WASHERS (32) to the the PILLOW
BLOCKS (17) as shown in FIGURE 4
4B
4A
4C
4D
1A
