STEP 9:
• Insert the two GUIDE RODS (27) (found in SHROUD KIT) into the base of the TOWER (1) as shown in FIGURE 9. Lubricate the
GUIDE RODS (27) with a silicon or teflon spray that is available at most hardware stores.
• Slide two WEIGHT STACK CUSHIONS (19) down over the GUIDE RODS (27). See FIGURE 9.
• Using
EXTREME CARE
place twenty 10 LB. WEIGHT PLATES (28) over the GUIDE RODS (27) as shown in FIGURE 9.
(NOTE:
If HEAVY WEIGHT OPTION is being used, slide ten 15LB. WEIGHT PLATES (29) over the GUIDE RODS (27) first, then
slide ten 10 LB. WEIGHT PLATES (28) over the GUIDE RODS.)
• Carefully Slide the HEAD PLATE (7) down over the GUIDE RODS (27) onto the weight stack as shown in FIGURE 9.
• Slide one WEIGHT STACK SELECTOR PIN (18) over the shaft on the HEAD PLATE (7) as shown in FIGURE 9.
FIGURE 9
10
• Slide two GUIDE ROD BUSHINGS (23) over each GUIDE ROD(27).
• Slide two 1” SHAFT COLLARS (21) over each GUIDE ROD (27) as shown in FIGURE 9.
• Place the GUIDE ROD SUPPORT (5) over the GUIDE RODS (27) as shown in FIGURE 9.
19
28
27
7
18
21
23
5
1
HEAVY WEIGHT OPTION
29
28
1A
