LIFAN Power USA Energy Storm ESI-7000iER-EFI, Operating Instructions And Owner'S Manual

Page: 19 / 60

19
PRE-OPERATING
INSTRUCTIONS: SETUP
WHEN ADDING FUEL
•
Turn generator off and let it cool for a minimum of three minutes before removing fuel cap.
• Turn and remove cap slowly in order to relieve residual tank pressure.
• Always fill the fuel tank with the unit outdoors.
• DO NOT overfill tank. Allow room for fuel expansion.
• Keep fuel away from sparks, open flames, heat, pilot lights, and other ignition sources.
ADD FUEL: Refer to Controls and Features section for diagrams.
1. Clean area around fuel cap, then remove fuel cap.
2. Pour fresh, clean regular automotive grade unleaded fuel with a minimum octane
rating of 85 into fuel tank. Do NOT mix fuel with oil. Fuel must have ethanol blend
of 10% or less. Pay close attention to the storage requirements of these fuels. Do
NOT overfill fuel tank.
3. Install the fuel cap. Rotate the fuel cap clockwise until
it is in its locked position. Wipe away any spilled fuel.
CAUTION: Alcohol-blended fuels (gasohol, ethanol, or methanol) will attract
moisture, which leads to separation and formation of acids during storage. Acid-
ic gas can damage the fuel system of an engine while in storage. To avoid engine
problems, the fuel system should be treated with a fuel stabilizer or drained if the
generator will not be started for thirty (30) days. If using a fuel stabilizer, follow the
manufacturer’s recommended instructions for use.
NEVER use chemical solvents or cleaners in the fuel tank for damage may occur.