28
QUICK GUIDE / DL-USB-PTZ20-W
NETWORK CONFIGURATION
Direct connection:
Connect the camera and computer by network connecting cable.
Internet connection mode: Connect the camera to the internet by Router or Switcher and then log into
the device via a browser or web page.
Note: Please do not put the power cable and network cable in places where they can be easily touched
to prevent an unstable video signal transmission due to contact with the cables.
The computer must have the network segment with the camera's IP address. The device will not be
accessible without the segment.
The camera default IP address is 192.168.5.163, segment 5 must be added via the computer.
First, open "Local Area Connection Properties" on the computer. Next, select the “Internet protocol
version 4(TCP/IPv4).” Select the “Internet” protocol version 4 (TCP/IPv4) to open the Internet Protocol
Version 4(TCP/IPv4) Properties window. Select “Advanced” to open the Advanced TCP/IP Settings and
add the IP and subnet mask. Click “Confirm” to finish adding the IP segment. Add the corresponding
network segment according to the revised IP address of the camera.
Note: The IP address to be added cannot be same as that of any other computers or devices. The
existence of this IP address needs to be verified before adding.
To verify whether the network segment has been successfully added, click “Start” and select
“Operation” to input cmd. Then click CONFIRM and open a DOS command window, ping 192.168.5.26,
and press the Enter key to display information as shown below:
After the camera powers on and performs a self-check, follow the steps above to verify
network connection.
Open a DOS command window, ping 192.168.5.163, and press the Enter key.
Web Page Login
Input the default IP address 192.168.5.163 in the browser and click Enter to open the Web Client
login page. User can login as administrator and normal user. If logging in as administrator (Default
User Name/Password: admin), users can preview, playback, and set configuration in the Web Client.
If logging in as a normal user (Default User Name/Password:user1 or user2), users can only preview,
playback, and logout. There is no option for configuration.
Note: Web access supports IE-based browsers, 360 browsers, etc.
Chrome login is available after a firmware update, but it will only support basic configurations and
previewing of videos. There will be no functionality to record video, voice volume, video capture,
or playback.
Download and Install Plug In for IE login
For first-time logins via IE browser, the login page will prompt: “Playback plug-in is not installed. Please
download and install!” Click on this message. Download and install MRWebXinstall.exe according to
the prompt.
Enter user name and password (default user name and password: "admin").
Users can manage and change user name, password, and etc.
