Option 3: Four-Position Handle Stand
The handle also offers the option to be used as a four-position handle-stand combination. This
configuration requires removing the wire stand and cup washers, if installed. The handle requires two
hands to operate, as described below.
Depending on how firmly the wire stand is installed, it may require the use of a tool like a screwdriver to
help pry the wire stand from the holes.
If you have installed the cup washers in Option 2, you will need to remove them to allow the handle
stand to be adjusted.
To Change the Handle Stand Position
Place the device face down. Pull both legs of the handle stand out from the case and rotate the handle
stand up or down a notch at a time until you reach the position you want. Release the stand and firmly
push the legs back into the case to stop it from moving.
Trying to adjust the handle stand without pulling the handle out as shown below may damage the
handle and post mechanism.
Pull out and rotate
www.prentrom.com
Accent 800
3
