LGMG SR3369E, Operation And Safety Manual

Page: 57 / 64

LGMG North America Inc. Operation and Safety Manual
51
9.9 Extending and retracting
of the platform
1) Lift the platform extension lock handle to
the horizontal position.
2) Push the platform extension lock handle to
extend the platform to the desired position.
Do not stand on the extension platform when
trying to extend the platform.
3) Press the platform extension lock handle to
engage the upper and lower teeth to lock
the extension platform.
9.10 How to operate the
safety arm
1) Lift the platform to a height of about 3.2
m/10.5ft from the ground.
2) Lift the safety arm and move it to the middle
of the scissor shaft bushing and rotate it up
to the vertical status.
3) Lower the platform until the safety arm is in
full contact with the shaft sleeve.
9.11 Fall protection
Personal Fall Protection Equipment (PFPE) is
not required to operate this machine. If PFPE is
required in the workplace or user rules, the
following rules apply:
All PFPEs must comply with the appropriate
government regulations and must be inspected
and used according to the manufacturer's
instructions.
9.12 Instructions for battery
and charger
Keep in mind the followings:
1
）
Do not use an external charger or a booster
battery.
2
）
Charge the battery in a well-ventilated area.
3
）
Charge the battery using the correct AC
input voltage indicated on the charger.
Charge the battery
1
）
Make sure the battery is connected before
charging.
2
）
Open the battery compartment cover. The
compartment cover should remain open
throughout the charging process.
3
）
Remove the battery vent cap and check the
battery acid level. If necessary, only add
the distilled water necessary for covering
the plate. Do not add excessive distilled
water before charging.
4
）
Reset the battery vent cap.
5
）
Connect the battery charger to a grounded
AC circuit.
6
）
The charger will give an indication when the
battery is fully charged.
7
）
Check the battery acid level at the end of
the charge cycle. Add the distilled water to
the bottom of the filling pipe. Do not add
excessive distilled water.
Instructions for battery filling and charging
1
）
Remove the battery vent cap and
permanently remove the plastic seal from
the battery vent.
2
）
Fill the battery acid till the indication level of
every unit can be over the plate.
Do not fill to the maximum level until the battery
charging process is completed. Excessive filling
may cause the battery acid to overflow during
charging. Sodium hydrogen carbonate and
water can be used to neutralize the overflowed
battery acid.
3
）
Install the battery vent cap.
4
）
Charge the battery.
5
）
Check the battery acid level at the end of
the charge cycle. Add the distilled water to
the bottom of the filling pipe. Do not add
excessive distilled water.
9.13 After each use
1) Choose a safe parking position, which can
be a solid level surface, without obstacles
and heavy traffic.