LGMG SR3369E, Operation And Safety Manual

Page: 36 / 64

LGMG North America Inc. Operation and Safety Manual
30
Display on PCU and ECU
Operation mode PCU display ECU display
Powered on but not moved Battery level
NVR.Inc
PCU System Ready
Travel forward or backward Battery level
NVR.Inc
PCU System Ready
Lift the platform
Battery level + machine mode
code
Machine mode code
Lower the platform Battery level + software version Software version
An error occurred Battery level + error code Error code
Chassis control mode CH
NVR.Inc Chassis
System Ready
System troubleshooting and fault code
In the error alarm state, the alarm code will flash once per second on the PCU display.
Table: Alarm code
Display Description Machine response
01 System initialization error Stop all actions
02 System communication error Stop all actions
03
The machine type is not set for the first use
Stop all actions
04 The set code is invalid Stop all actions
05 Communication interruption error Stop all actions
12
The chassis up or down button is enabled incorrectly when
starting Stop all chassis controls
13 Limit switch redundancy error Stop lifting and driving
14 Communication failure with ZAPI controller 1 Stop lifting and driving
15 Communication failure with ZAPI controller 2 Stop lifting and driving
16 Outrigger 1 solenoid coil failure Stop lifting and driving
17 Outrigger 2 solenoid valve coil failure Stop lifting and driving
19 Horn coil error Stop lifting and driving
27 Proportional solenoid valve coil error Stop lifting and driving
31 Pressure sensor error Stop all actions
32 Angle sensor error Stop all actions
33 Outrigger 4 solenoid valve coil failure Stop lifting and driving
34 Perform emergency drop 1S after overload alarm Save fault code only
35 No load full load calibration data error Show alarm only
42
The platform left turn button is pressed incorrectly when
starting. Show alarm only
43
The platform right turn button is pressed incorrectly when
starting. Show alarm only
44 ZAPI controller failure Show fault only