LGMG SR0818D, Maintenance Manual, Page: 22 / 54

Maintenance Manual of Rough Terrain
Mobile Elevating Work Platform
16
1) Carefully open the cover for the cooling
system.
2) Loosen the cooler exhaust bolts that may
be present.
3) Fill the coolant to max or the filling limit
position.
4) Open the possible heater and switch to the
maximum gear, to fill the heating circuit and
exhaust.
5) Close the cooler cover.
6) Run the engine to the running temperature.
7) Shut down the engine.
8) Check the coolant liquid level when the
engine is cooled, and fill it to max if
necessary.
△
! Note: The coolant with different
freezing point should be selected
according
to the local ambient
temperature, the principle is that the
freezing point of coolant is 10
℃
-15
℃
lower than the local minimum
temperature.
1.17.10 Check for engine
belt-DeutzD2.9L4
Check it every 8 hours or every day.
△
!
Only when the engine is stationary can
the belt drive operation be carried out.
△
!
There is danger of burn. Be cautious of
high-temperature engine components.
Contact with them may cause serious burn.
Belt Check
1) Visually inspect whether all belt drives for
damage.
2) Replace damaged components.
3) Reinstall the protector if necessary.
4) When it is a new belt, check whether the
position is correct. After running for 15
minutes, check the tension.
Replacement of Belt
Replace it every 2,000 hours or two years,
whichever comes first.
1) Loosen bolts (1,2,3) and nuts.
2) Move the engine in direction B, until the belt
is lose.
3) Remove the old belt, and install a mew one.
4) Move the engine in direction A until the
correct belt tension is reached.
5) Check the belt tension.
6) Tighten the bolts and nuts.
Tightening torque
Screw 1 42 Nm
Screw 2 30 Nm
Screw 3 M8 30 Nm
Screw 3 M10 42 Nm
1.18 Engine
maintenance-Kubota
1.18.1 Check for Engine Oil
Level
△
!
Do not operate on running
engines!
No smoking and open fires!
Be careful when contacting with high