11
EN
Installation Place
Requirements
Location
133 cm
5 cm
5 cm
70 cm
* 199 cm
15 cm
* 199 cm : additionally needed for service.
Level floor
: Allowable slope under the entire
appliance is 1°.
Power outlet
: Must be within 1.5 meters of
either side of the location of the appliance.
Additional Clearance
: 5 cm at the sides and
10 cm behind the unit.
•
These products may damage the finish or
controls.
WARNING
•
The plug must be plugged into an appropriate
outlet that is properly installed and grounded
in accordance with all local codes and
ordinances.
Positioning
•
Install the appliance on a flat hard floor. Do not
install on an elevated surface.
•
Make sure that air circulation around the
appliance is not impeded by carpets, rugs, etc.
•
Never try to correct any unevenness in the
floor with pieces of wood, cardboard or similar
materials under the appliance.
•
Do not install the appliance in rooms where
freezing temperatures may occur. Frozen
hoses may burst under pressure. The reliability
of the electronic control unit may be impaired
at temperatures below freezing point.
•
Ensure that when the appliance is installed,
it is easily accessible for an engineer in the
event of a breakdown.
•
With the appliance installed, adjust all four
feet using a transit bolt spanner to ensure
the appliance is stable, and a clearance of
approximately 15 cm is left between the top
of the appliance and the underside of any
work-top.
•
If the appliance is delivered in winter and
temperatures are below freezing, place the
appliance at room temperature for a few hours
before putting it into operation.
•
Do not use a drip pan as it can block the
drawer. Using the drip pan may result in
increased vibration and noise during operation.
WARNING
•
This equipment is not designed for maritime
use or for use in mobile installations such as
caravans, aircraft etc.
•
DO NOT Stack, store, or place any items or
appliances on top of the Main Washer.
Electrical Connection
•
Do not use an extension cord or double
adapter.
•
Always unplug the appliance and turn off the
water supply after use.
•
Connect the appliance to an earthed socket in
accordance with current wiring regulations.
•
The appliance must be positioned so that the
plug is easily accessible.
•
Repairs to the appliance must only be carried
out by qualified personnel. Repairs carried out
by inexperienced persons may cause injury
or serious malfunctioning. Contact your local
service centre.
Summary of Contents for WTP357B
Page 39: ...Memo ...
Page 40: ......