3
ENGLISH
Make sure the holes on the pedestal align with the
holes in the appliance, then install 4 screws at each
corner to securely attach the appliance to the pedestal.
1
2
3
4
5
6
7
8
9
10
11
12
Level the washer/combo on the pedestal by
adjusting the feet.
1
2
3
4
5
6
7
8
9
10
11
12
Lock nut
Adjustable feet
Adjustable feet
Move the washer/combo to the desired place.
1
2
3
4
5
6
7
8
9
10
11
12
Diagonal Check
When pushing down the edges of
the washing machine top plate
diagonally, the machine should not
move up and down at all.(Please
check both directions.) If the
machine rocks when pushing the
machine top plate diagonally, adjust
the feet again.
NOTE
To make sure that the washer is properly level, run the
washer with a test load: place approximately 6 pounds
of laundry in the machine. Then press POWER, press
RINSE+SPIN, and then press the START/PAUSE
button. See the following sections for additional
information on cycle selection and operation. Verify
that the washer does not rock or vibrate excessively
during the spin cycle. If the washer vibrates or shakes,
adjust the leveling feet until the washer is stable and
retest.
NOTE
If the screws are not installed properly, noise and
vibration may result.
For WASHER: 16 SCREWS
For DRYER: 8 SCREWS
NOTE
The appliance and pedestal assembly must be placed
on a solid and level floor for proper operation. Adjust
the legs of the appliance and pedestal by turning with
a wrench. Then, adjust the lock nut toward the
pedestal while holding the pedestal leg using a
wrench.
NOTE
Lock nut
Adjustable feet
Adjustable feet
