LG WD(M)-12331(6)AD, Owner'S Manual

Page: 10 / 32

9
nstallation I
Normal Tap without thread & screw type inlet hose
Normal Tap without thread & one touch type inlet hose
1 .
Unscrew the fixing screw to
attach the tap.
2 .
Push the connector up till the
rubber packing is in tight contact
with the tap. Then tighten the 4
screws.
3 .
Push the water supply hose
vertically upwards so that the
rubber packing within in the
hose can adhere completely to
the tap and then tighten it by
screwing it to the right.
1 .
Untighten the upper connector
screw.
2 .
Push the upper connector up till
the rubber packing is in tight
contact with the tap. Then
tighten the 4 screws.
3.
Connect the water supply hose
to the middle connector,
pushing the plate down.
• Your machine comes with only
cold water connection.
• Make sure that there are no
kinks in the hose and that it is
not crushed.
• Make sure that the rubber seal
is inside the hose connector.
Upper
Connector
Rubber
packing
Middle
connector
Fixing screw
Guide plate
Connector
Rubber seal
Hose connector
Used the horizontal tap
Horizontal tap
Extension tap
Square tap
Rubber packing
Upper
Connector
Middle
connector
Plate
Upper
Connector
Water supply
hose
• In case the diameter of the tap is
large remove the guide plate.
• Turn the middle connector not
to have water leaked.
• To separate the water supply
hose from the middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.