18
OPERATION
6
Clean Filter
7
Fan Speed
Press to set the Fan Speed (V.vent) to
Low (Bajo) (F1), Medium (Medio) (F2) or
High (Alto) (F3).
8
Temperature Control
The thermostat monitors room temperature
to maintain the desired temperature. The
thermostat can be set between 16 °C–30 °C
(60 °F–86 °F). Press
9
Energy Saver
In this mode the compressor and fan turn
off when the set temperature is achieved.
Approximately every 3 minutes the fan turns
on to allow the unit sensor to accurately
determine if more cooling is needed.
10 Clear
Cancel Sleep and Timer settings. Also set
the Diagnosis if held for 5 seconds.
NOTE
●
Auto Restart:
If the air conditioner turns off due
to a power outage, it will restart automatically
once the power is restored, with the same
settings as were set before the unit turned off.
●
Energy Saver (AA.Energía) :
The unit defaults to
the Energy Saver (AA.Energía) mode each time the
unit is switched on except in Fan (Vent.) mode or
when power is restored after an electrical power
outage.
●
The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
controller and the air conditioner.
or
arrows to
increase or decrease temperature setting.
Using the Light Off Function
In the Cooling and Dry Mode, Moisture is
generated inside the indoor unit. This function
removes such moisture.
You can set the brightness of the control panel,
Using the Auto Clean Function
3 seconds, or
●
Press
the control panel.
Press
Press
button on the remote control for
button on the remote
and
Dormir
button together on
Mode
Modo
●
control for 3 seconds.
●
is displayed on the remote control.
Energy Saver
●
NOTE
Turn on/off the control panel.
●
NOTE
If you turn off the unit, the fan continues to run
for 10 minutes and cleans the inside of the
indoor unit.
●
The Clean Filter (Limpiar filtro) LED lights
up to notify you that the filter needs to be
cleaned. After cleaning the filter, press
Temp
and
together on the control
panel to turn off the Clean Filter (Limpiar
filtro) light.
NOTE
control panel, not the remote control.
●
●
This feature is a reminder to clean the air
light turns on after 250 hours of operation.
filter for more efficient operation. The LED
The filter reset must be done using the
