35
EN
Symptoms
Possible Cause & Solution
Appliance will not
operate.
Control panel has powered off due to inactivity.
•
This is normal. Press the
POWER
button to turn on the appliance.
Appliance is unplugged.
•
Make sure that the cord is plugged securely into a working outlet.
Water supply is turned off.
•
Turn on the water supply tap completely
Controls are not set properly.
•
Make sure the cycle is correctly set. Close the door and press the
START/PAUSE
button
Door is open.
•
Close the door completely and make sure that nothing is caught at the
door.
Circuit breaker/fuse is tripped/blown.
•
Check house circuit breakers/fuses. Replace fuses or reset breaker. The
appliance should be on a dedicated branch circuit. The appliance will
resume the cycle where it stopped once power is restored.
Control needs to be reset.
•
Press the
POWER
button, then reselect the desired programme and press
the
START/PAUSE
button.
START/PAUSE was not pressed after a cycle was set.
•
Press the
POWER
button, then reselect the desired cycle and press the
START/PAUSE
button. If the
START/PAUSE
button is not pressed within a
certain time, the appliance will be turned off.
Extremely low water pressure.
•
Check another tap in the house to make sure that household water
pressure is adequate.
Appliance is too cold.
•
If the appliance has been exposed to temperatures below freezing for an
extended period of time, allow it to warm up before pressing the
POWER
button.
Appliance is heating the water or making steam. (some models only)
•
The drum in the appliance may stop operating temporarily during certain
cycles, while water is safely heated to a set temperature.
