LG PTND01B0E, Installation Manual

Page: 16 / 29

16
CONNECT WITH AN INVERTER DRIVE KIT
ENGLISH
Inverter stand-by mode
Press the button more
than 2 seconds?
1.
YES
YES
YES
YES
No
2.
3.
4.
When the set up value is ‘40,’ display the below
1 digit
10 digit
• Enter into a setup mode
1. LOW (DI contact point: low wind frequency set up mode)
2. MID (DI contact point: medium wind frequency set up mode)
3. STR (DI contact point: strong wind frequency set up mode)
4. Error checking mode (display the most recent 3 errors)
• After selecting one of above 4 menu using
◀
,
▶
(move left and right/
0~9), press ◉ button more than 2 seconds? (When “X” button is pushed,
go back to stand-by mode)
When menu 1, 2, or 3 is selected
Set up value of the relevant menu is displayed.
Press
◉
button more than 2 seconds?
(When “X” button is pushed, go back to stand-by
mode)
When
◉
button is pressed more than 2 seconds,
1 digit number flickers, and after change using t,
u buttons, pressing
◉
button more than 2
seconds confirms the value and 10 digit number
flickers.
While 10 digit number is flickering, change the
value by using t, u buttons, and pressing
◉
button more than 2 seconds will make the
changed value flicker 5 times and confirm it. After
confirmation, pressing
◉ button for 2 seconds or
push X button 2 times will exit from set up mode.
* When pushing X button after changing 1 digit
number without changing10 digit number, 1 digit
value will not be changed and go back to set up
mode.
When menu 4 is selected
Most recently occurred 3 errors could be checked
using
ȭ+ȯ buttons.
Ex) the most recent error is 193 and number 1 is
selected
and are displayed
alternately.
(When “X” button is pushed, go back to set up
mode)