7
ENGLISH
Tools you will need
• Phillips head + driver (manual or motorized), Ø 3/6/8mm Drill bit,
Level, Stud finder, Drill
How to attach to masonry walls
Please follow the below direction.
1 Use a drill bit Ø 8 mm to drill a hole for the anchor location within
a depth of 80 mm to 100 mm.
2 Clean the drilled hole.
3 Insert the sealed wall mounting anchor to the hole. (When
inserting the anchor, use a hammer.)
Wall mounting anchor
4 Set the wall mount on the wall by aligning to the location of the
hole. and, set the angle adjusting part to face upward.
5 Align the wall mounting screw to the hole and tighten it. Then,
fasten the screws at torque of 45 kgf/cm to 60 kgf/cm.
Wall mounting screw
• Check the material of the wall and the thickness of the finishing.
• Use the Wall mount anchor for wall material of concrete, light
concrete, strong natural stone, soft natural stone masonry brick
and hallow block that do not crack.
Wall Material
Tools
Wall Width
Concrete
Wall mounting anchor,
Wall mounting screw,
Ø 3/6/8mm Drill bit
45 mm
Brick
Natural stone
Metal Panel
Plywood
Wall mounting screw,
Ø 3/6/8mm Drill bit
30 mm
EPS Panel
Penerate the wall
Plaste
Plywood
30 mm
• Do not mount the device on the walls made from plasterboard or
medium density fiberboard (MDF). In this case, the anchor and
screws must be inserted into the concrete behind the finish surface.
If there is no concrete on the other side, then you must first install a
separate hanger to securely install the anchors and screws.
• When installing the product on wall material not designated,
install the product so that each location can withstand the pull out
load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.
• Use the Ø 8 mm drill bit for concrete and hammer (Impact) drill.
MFL69830001_OLED_W7_S_HK_Eng.indd 7
2017-01-06 4:03:58
