LG MM-624AMZ, Owner'S Manual

Page: 10 / 14

9
Programming Pads
Oven is shipped from the factory for single pad programming. To change
the oven default to allow double pad programming, see User Option section.
To change the amount of time or the power level for a preset pad:
1. Open oven door.
• READY displays.
• If door is closed or STOP pad is pressed before
programming is complete, changes are discarded and
microwave exits programming mode.
2. Press and hold pad 1 for approximately 5 seconds.
• This begins programming mode.
• Microwave will beep and
P:O
displays. Oven is in programming mode.
3. Press pad to be reprogrammed.
• Press two pads if reprogramming a double pad program.
• Power level and cooking time display.
• If power level does not display, microwave is set to full power.
4. Enter cooking time by using the number pads.
5. Press a power level pad to change power level if desired.
6. Press START pad to set new programming to the pad.
• If START is not pressed, changes will not be saved.
•
P:O
displays.
7. Press STOP pad or close oven door to exit programming mode.
Programming the Oven Control
(Electronic Control)
Programming Multiple Stages
Stage cooking allows consecutive cooking cycles without interruption.
Up to four different cooking cycles can be programmed into a memory pad.
To use stage cooking:
1. Follow steps 1 through 5 above.
6. Press TIME ENTRY pad.
• Display briefly shows the pad number that is being
programmed and the stage number to the upper right.
• Display changes to cook time and power level for the next stage.
7. Enter cook time and power level as in steps 4 and 5.
• To enter another cooking stage for that pad, press TIME
ENTRY pad again.
• Up to four different stages can be programmed.
8. Press START pad to set new programming changes to the pad.
9. Press STOP pad or close oven door to exit programming mode.
The display shows
P:
not
P:0
.
When set to double pad
programming, the display will show
P:
when programming pads for double digit
cooking sequences. To change the oven
to default to allow single pad
programming only, see the
User Option
section.
1
Med.
50%
START
Time
Entr y
START
X2 Programming
(some models)
This feature allows a
preset percentage of original cook
time, called a cooking factor, to be
added to a cook sequence.
To change the cooking factor:
1. Open oven door.
2. Press and hold pad 1 for
approximately 5 seconds.
3. Press pad to be reprogrammed.
4. Press the X2 pad.
5. Press a numbered pad to change
the cooking factor.
• Cooking factor can be set from
10% to 100%.
• Default is 80%.
• Pad 5 would change the
cooking factor to 50%.
• Pad 3 would change the
cooking factor to 30%.
6. Press START pad to save
changes.
X
2
Canceling
Mistakes
If oven is not cooking,
press STOP pad to clear display.
If oven is cooking, press STOP pad
once to stop oven, then again to clear
display. If oven door is open and time
shows in display, close oven door and
press STOP pad to clear display.
STOP