LG MG210, Service Manual, Page: 17 / 127

3. H/W Circuit Description
- 16 -
3.2.2. Synthesizer
The Aero II transceiver integrates two complete PLLs including VCOs, varactors, resonators, loop
filters, reference and VCO dividers, and phase detectors. The RF PLL uses two multiplexed VCOs.
The RF1 VCO is used for receive mode, and the RF2 VCO is used for transmit mode. The IF PLL is
used only during transmit mode. All VCO tuning inductors are also integrated. The IF and RF output
frequencies are set by programming the N-Divider registers, NRF1, NRF2 and NIF. Programming the
N-Divider register for either RF1 or RF2 automatically selects the proper VCO.
Transmit modes should always use f
∅
= 200kHz. The IF and RF output frequencies are set by
programming the N-Divider registers and also programmed via 3-wire interface with external system
controler.
Serial
I/O
Serial
I/O
Baseband
(TI)
U100
IOTA
Shrink
+
U101
Calypso
Baseband
(TI)
U100
IOTA
Shrink
+
U101
Calypso
U400/Si4210
RF1
RF2
PDIB
26MHz
X400
VC-TCXO
SCLK
SDIO
SEN
PDN
XTAL1
XOUT
XEN
Power
control
Power
control
Self
Tune
Self
Tune
1/N
1/N
1/N
1/N
DET
DET
Self
Tune
Self
Tune
DET
DET
To Rx/Tx
To Tx
RF PLL
IF PLL
PDRB
SDOSEL[4:0]
N
IF
[15:0]
N
RF1
[15:0]
N
RF2
[15:0]
1,2
1,2
65,130
65,130
÷ ÷
φ
φ
Figure 2. Synthesizer Block
Z3X-BOX.COM