10
Multi Air Conditioner
Installation
• Drill the piping hole with a Ø65mm hole
core drill. Drill the piping hole at either the
right or the left with the hole slightly slanted
to the outdoor side.
Drill a hole in the wall
5-7mm
(3/16"~5/16")
Indoor
WALL
Outdoor
Sticking the installation guide map and fixing Indoor unit
Plastic anchors
INSTALLATION GUIDE MAP
10mm
INST
ALLA
TION GU
INST
AIIA
TION GUIDE MAP
Put an Installation Guide Map on the desired surface.
Make a hole with diameter of 6mm and depth of
30-35mm when piercing a screw point.
Drive the four plastic anchors into drilled points.
Hang the hole of product at the upper screws.
(In this time, Remove the map)
(Falling attention)
Check the fixed product with light power.
Adjust level even by level guage and fix to installation
for reference on the wall.
Drill the piercing part for connecting pipe as diameter
Ø65mm. (In case of piercing rear surface)
Refer to No. 5 on this page when making a hole in the wall.
First, Drive the two points of the upper parts by screws
(Leave 10mm for hanging product)
Drive the lower parts after facing the hole of product
with plastic anchors, and fix completely the upper
screws.
In case of nothing wrong in the matter, connect the pipe
and the wire. (Installation manual reference)
Horizontality
INST
ALLA
TION GUIDE MAP
Plastic anchors
INST
ALLA
TION GUIDE MAP
INST
ALLA
TION GUIDE MAP
Hanger hole
(Rear side of
product)
