LG M2400HR, Service Manual

Page: 11 / 36

Service Manual 11
Operation
Operation
• Powerful and quiet cooling.
• Slide-in and slide-out chassis for the simple installation and service.
• Reversible inlet grille.
• Side air-intake, side cooled-air discharge.
• Built in adjustable THERMOSTAT/THERMISTOR.
• Washable one-touch filter.
• Compact size.
CAUTION: When the air conditioner has been performing its cooling operation
and is turned off or set to the fan position, wait at least 3 minutes before resetting
to the cooling operation again.
Features
Control Locations Function of Controls
• THERMOSTAT
Turn the thermostat control to the desired setting.
The centrol position is a normal setting for average con-
ditions. You can change this setting, if necessary, in
accordance with your temperature preference.
The thermostat automatically controls cooling or heat-
ing, but the fan runs continuously whenever the air con-
ditioner is in operation. If the room is too warm, turn the
thermostat control clockwise. If the room is too cool, turn
the themostat control anticlockwise.
• OPERATION
OFF ( ) :Turns the air conditioner off.
FAN ( ) : Permits the low fan speed operation
without cooling (heating).
LOW COOL
( ) : Permits cooling with the low fan
speed operation.
HIGH COOL
( ) : Permits cooling with the high fan
speed operation.
LOW HEAT
( ) : Permits heating with the low fan
speed operation.
HIGH HEAT
( ) : Permits heating with the high fan
speed operation.
• AUTO SWING
ON : Starts the operation of air swing.
OFF : Stops the operation of air swing.
• Before you turn the unit off, please press the Auto
Swing switch to off.
Thermostat Operation
Wait Three Minutes
Before Restarting
Cooler Warmer
Off
Auto Swing
Off On
Fan Fan
Low Heat Low Cool
High Cool High Heat
Part A
Part B
VENT CLOSE OPEN
A slight heat odor may come from the unit
when first switching to HEAT after the cool-
ing season is over. This odor, caused by fine
dust particles on the heater, will disappear
quickly.
• VENTILATION
The ventilation lever must be in the CLOSE position in order
to maintain the best cooling conditions.
When a fresh air is necessary in the room, set the ventilation
lever to the OPEN position.
The damper is opened and room air is exhausted.
NOTE: Before using the ventilation feature,
make the lever, as shown. First, pull down
part A to horizontal line with part B .
NOTICE
o