27
INSTALLATION MENU
ENGLISH
HCEC Setup
CEC Mode
-
Determines whether to use TVLink-CEC. The default value is No. When No is selected, you cannot set subitems.
-
If ‘TVLink-CEC’ is selected, TV will not directly work for key input except for power key. And volume related keys will work just in case of
Follower volume control mode. (for more detailed information regarding the scenario of volume control, please refer to “TVLink-CEC protocol”
document)
IR Decoding
-
If 'IR Decoding' is set as 'Yes', TV decodes IR signal to generate a CEC command and sends it to device.
-
If CEC mode is 'TVLink-CEC' with IR Decoding 'No', TV Will just pass through the IR to device without any reaction by itself.
Device ID
-
Sets the ID of a device(Logical Address) connected to the CEC Line. You can choose between ‘All’ and ‘E’.
-
The default value is ‘All’.
StandBy
-
Set the sending and receiving scenario of OpStandBy(0x0c) command.
-
Ths detailed scenario is described on the table below.
Send
Receive
Send Only
O
X
Receive Only
X
O
All
O
O
Off
X
X
Forced Initialize
-
This setting will be enabled When CEC mode is set as ‘TVLink-CEC’
-
If ‘Enable” is selected, TV will change its input source to HDMI1 by any HDMI-CEC simulation from a device.
HTNG Hotel Mode
-
If you use following functions via TVLink-HCEC, HTNG Hotel mode will be set as “Yes” automatically. (*Power On Default, Start Volume,
Maximum Volume, Minimum Volume, or Start Volume)
-
Even if ‘Hotel Mode Operation’ is set as No, above settings are still effective.
