Instructions for the installer
2. Installation
2.1 Electrical connection
Make sure the voltage and the cross-section of the power cord
match the specifications indicated on the identification plate
positioned on the frame of the oven door.
Do not remove this
plate for any reason.
The appliance must be connected to earth in compliance with
electrical system safety regulations.
If a plug and socket connection is being used make sure that the
plug and socket are compatible. Avoid use of adapters and shunts
as these could cause overheating and burns. Extension leads must
not be used.
If a fixed connection is being used, fit the power line with an
omnipolar circuit breaker or isolation switch with a contact opening
gap equal to or greater than
3 mm
, in an easily accessible position
close to the appliance.
For operation on 220-240V~ :
use an
H05RR-F / H05RN-F type three-core cable
(3 x 1.5 mm
2
).
The end to be connected to the appliance
must be an earth wire (yellow-green) at
least 20 mm longer.
The manufacturer declines all responsibility
for damage to
persons or things caused by non-observance of the above
prescriptions or by interference with any part of the appliance.
6