Line Lock Phase Adjustment
➀
②
➂
When using a camera switcher to connect 2
cameras or more to one monitor, there may be a
vertical jump of the images when switched.
In such a case, refer to the below.
- The vertical sync phase can be manually adjusted
within the range approximately from -90
o
C to
+90
o
C.
- Switch the display on the monitor from camera1
to camera2.
Adjust the PHASE volume on camera2 until the
vertical jump of the image stops.
If more than two cameras are used, please repeat
this procedure for all the cameras.
- If you can’t adjust vertical sync. phase, please
exchange the polarity of input terminal.
➀
Camera switcher
②
Monitor
➂
Vertical phase
18
LVC-SX811HP_ENG_MFL-180 7/19/07 3:04 PM Page 18
