LG LVC-S10, Operating Instructions Manual

Page: 8 / 23

Mounting Auto Iris Lens
1. Mount the lens by turning it clockwise on the lens mount of the camera.
2. Set the slide switch of rear panel to your lens type
3. Connect the lens cable to the auto iris lens connector on the side of the
camera.
4. If the lens connection is not connector type but wired cable type, connect
this cable to iris terminal block at rear panel.
In this case, note the terminal assignment of DC or Video lens.
Notes : Rotate the lever clockwise until it stops.
If the lever is not at the end, the inner glass or CCD image sensor may be
damaged.
Auto Iris 4 Pin Plug Connector
Alarm Connection
1. Connect the alarm out from terminal to VCR or other equipment.
2. Set the alarm mode by using Menu function (see page 13)
Notes : Alarm GND is shared with Auto Iris GND
8
Lens No Connection
DC
1
2
3
4 Damp -
Damp +
Drive +
Drive -
Lens No Connection
Video
1
2
3
4 DC 12V
NOT USED
Video
Gnd
Auto
IRIS
Lens
Flange-Back Focus adjusting lever
1
2
Alarm Out
Da-
VCC Video GND
Da+ Dr+ Dr-
1 2
4 3
Alarm
/ VCR
Alarm Out
Da-
VCC Video GND
Da+ Dr+ Dr-