12
Cassette Type Air Conditioner
Installation
WIRED REMOTE CONTROL INSTALLATION
(PQRCUSA0)
1. Disassemble the remote controller from
the installation board.
•
Use the driver as shown in the right picture
and insert it into the hole with the arrow. And
then you pull the driver in the front direction,
the remote controller will be separated.
2. Connect the remote controller cable to
the wired remote controller installation
board as shown in the right picture.
3. After fixing the cable to the guide slot,
attach the wired remote controller
installation board at the desired location.
• Before fixing the remote controller cable to
the guide slot, remove any clogged part of
the case in the direction to install before the
installation.
4. After locating the wired remote
controller installation board at the
desired location, screw the unit firmly.
(When there is a buried box, install the
wired remote controller board to fit the
buried box.)
• Use the screw provided.
5. After fixing the top part of the remote
controller to the installation board as
shown in beside picture, press the
bottom part to assemble the controller
to itʼs board.
12V
Red wire
SIG
Yellow wire
GND
Black wire
j
The remote controller cable is connected as factory default.
12V SIG GND
Red
Yellow
Black
Remote Controller
Cable
Guide slot
Fixate the remote
controller cable
to the guide slot.
Use the screws
for fixate the unit
firmly on the wall.
Installation board
<Front side of
installation board>
<Rear side of
installation board>
Top
Bottom
Wall
Side
Wall
Side
Wall
Side
Summary of Contents for LT-C548DLE2
Page 32: ......
