13
12
2.4 Installation
You should follow each step carefully as shown below
in order to guarantee proper operation of CDMA
Fixed Wireless Telephone.
STEP I. Check Components
▶
Fixed Wireless Terminal is supplied with the
following standard unit and accessories:
1. LST-270T Unit
-1EA-
2. Dipole Antenna
-1EA-
3. Backup Battery
-1EA-
4. User Guide
-1EA-
5. AC/DC Power Adapter
-1EA-
▶
Please make sure that these components are
present and check for evidence of shipping before
you begin the unit installation.
▶
If components are missing or damage is found,
contact your authorized LGE Service Center
immediately.
STEP II. Place the Terminal
▶
Place the terminal on the stable flat secure surface
area (desk, table, etc.).
Avoid direct exposure to the sunlight and damp
areas.
▶
Read the SAFETY INFORMATION located at the
first part of this document before you place the
terminal.
STEP III. Connect Components
▶
Connect the Dipole antenna to the TNC connector
located at the topside of the terminal. (See Figure 1
to locate the TNC connector.)
If you have placed the terminal on the flat surface,
position the antenna up side.
▶
Connect your phone cord to the RJ-11 port located
at the side of the terminal.
▶
Connect the battery cable to the DC battery
connector at the side of the terminal.
- Remove the battery compartment cover.
Introduction
Introduction
Introduction
2.3 3 LEDs Indicators
< Table 1 >
Introduction
WIRELESS LOCAL LOOP
LLEED
D
C
CO
OLLO
OR
R
O
Op
peerraattiinngg C
Co
onnd
diittiio
onn
GREEN-solid
Good Signal
SIGNAL LED
ORANGE-solid
Poor Signal
RED-solid
No Service Area
MODE LED
GREEN - blink
Voice Message is received
(0.5sec On / 0.5sec Off)
GREEN-solid
DC Power is applied
POWER LED
RED-solid
Battery Power is applied
ORANGE-solid
Low Battery
LST-270T 2006.1.11 4:32 PM 페이지12
