10
Introduction
Installation for Wall Mounting
▶
To mount terminal on the wall, please follow the
procedure to install it correctly.
1. Determine suitable location to mount terminal
with mounting template.
2. Mark the two openings and select round or pan-
head type screw.
3. Drill out the holes with drill bit smaller in
diameter than the screws.
4. Secure two screws into the wall, leaving about
65mm gap between the screw heads.
5. Insert the DC power jack into an electrical outlet
and attach the telephone line into the Phone
Jack (RJ-11) of the terminal.
6. Place the terminal over the two screws.
7. Slide the terminal downward until the screw head
is locked at the top of the opening and the
terminal is secure.
8. Check that set is fixed on the screws.
11
Introduction
Introduction
Introduction
2.2 Front, Side and Rear View of the Terminal
WIRELESS LOCAL LOOP
< Figure 1 >
< Mounting Template >
IIT
TEEM
M
D
DEES
SC
CR
RIIPPT
TIIO
ON
N
(1) LEDs
Indicate the status of the unit
(2) DC IN 12V
AC/DC Power Adapter
(3) Battery Switch
Battery On/Off Switch
(4) TEL (RJ-11 Port)
Connecting Ports for SLT
(Single Line Telephone)
(5) DATA Port (RJ-45 Port)
Connecting Port for Repair(RS-232C)
(6) Antenna Connector
Connecting Port for TNC Antenna
(7) Power
Power On/Off Key
LST-270T 2006.1.11 4:32 PM 페이지10
