23
INSTALLATION
ENGLISH
Connecting the Water Line
Before Beginning
This water line installation is not covered by the
refrigerator warranty. Follow these instructions
carefully to minimize the risk of expensive water
damage.
If necessary, call a qualified plumber to correct water
hammer before installing the water supply line to
the refrigerator. Water banging in the pipes, or water
hammer in residential plumbing can cause damage
to refrigerator parts and lead to water leakage or
flooding.
•
Turn the icemaker OFF if the refrigerator will be
used before the water line is connected.
•
Do not install the icemaker tubing in areas where
the ambient temperatures fall below freezing.
WARNING
•
Connect to potable water supply only.
CAUTION
•
To prevent burns and product damage, only
connect the refrigerator water line to a cold water
supply.
•
Wear eye protection during installation to prevent
injury.
Water Pressure
You will need a cold water supply.
Water Pressure
models with
water filter
20–120 psi
(138 - 827 kPa)
where reverse
osmosis
water filtration
system is
connected to
a cold water
supply
40–60 psi minimum to reverse
osmosis system (2.8 – 4.2 kgf/cm
2
,or
less than 2–3 seconds to fill a cup of
7 oz capacity)
If the water pressure from the reverse osmosis
system is less than 20 psi or 138 kPa or 1.4 kgf/ cm
2
(takes more than 4 seconds to fill a cup of 7 oz or
198 cc capacity):
•
Check to see if the sediment filter in the reverse
osmosis system is blocked. Replace the filter if
necessary.
•
Allow the storage tank on the reverse osmosis
system to refill after heavy usage.
•
If the water pressure remains low, call a licensed,
qualified plumber.
•
All installations must be in accordance with local
plumbing code requirements.
Supplies Needed
•
Copper or PEX Tubing
, ¼ in. outer diameter, to
connect the refrigerator to the water supply. Be sure
both ends of the tubing are cut square. To determine
how much tubing you need, measure the distance
from the water valve on the back of the refrigerator
to the water supply pipe. Then, add 8 feet (2.4 m).
Be sure there is sufficient extra tubing (about 8 feet
[2.4 m] coiled into 3 turns of about 10 in. [25 cm]
diameter) to allow the refrigerator to move out from
the wall after installation.
•
Power drill.
•
½ in. or adjustable wrench.
•
Flat-blade and Phillips-head screwdrivers.
•
Two ¼ in. outer diameter compression nuts and
2 ferrules (sleeves)
to connect the copper tubing to
the shutoff valve and the refrigerator water valve.
•
If your existing copper water line has a flared fitting
at the end, purchase an adapter (available at
plumbing supply stores) to connect the water line
to the refrigerator OR cut off the flared fitting with a
tube cutter and then use a compression fitting.
