Operation
39
4
Oper
ation
Home position
The home position is the camera’s basic position.
The camera returns to this position whenever you want.
Use the following procedure to make the home position.
1. Select [HOME POSITION] option on the [SPECIAL]
menu.
2. Use [Near] or [Far] button to set it ON.
3. Press [Open] or [Close] button.
4. Select [SET] option and then press [Open] or [Close]
button.
5. Select the home position where you want and then
press [Open] or [Close] button.
6. Select [DWELL TIME] option and then select the dwell
time.
7. Select [RETURN] option and press [Open] or [Close]
button to exit the setting menu.
Go to Home position
1. Select [HOME POSITION] option on the [SPECIAL]
menu.
2. Use [Near] or [Far] button to set it ON.
3. Press [Open] or [Close] button.
4. Select [GO] option and then press [Open] or [Close]
button. The camera will move to the home position.
If you do not want to use the home position function,
set the [HOME POSITION] option to [OFF].
,
Note
Auto return
This function can be used to specify automatic return to a
particular mode if a certain amount of time elapses without
any operation being performed.
1. Select [AUTO RETURN] option on the [SPECIAL] menu.
2. Use [Near] or [Far] button to set it [ON] and then press
[Open] or [Close] button.
3. Select [RETURN TIME] option and then select the auto
return time.
4. Select [RETURN] option and press [Open] or [Close]
button to exit the setting menu.
Tilt limit
You can specify the tilt range. If you set this function, the
camera is able to tilt from 10º to 170º.
1. Select [TILT LIMIT] option on the [SPECIAL] menu.
2. Use [Near] or [Far] button to set it [ON]. If you do not
want to use this function, set it to [OFF].
Motion Detection
The motion detection detects the moving objects in
the scene by monitoring changes in brightness level.
1. Select [MOTION DET] option on the [SPECIAL] menu.
2. Use [Near] or [Far] button to set it [ON]. If you do not
want to use this function, set it to [OFF].
3. Press [Open] or [Close] button.
4. Use [Near] or [Far] button to set the [SENSITIVITY]
option.
Communication
This setting is required to establish a connection between
the system controller and the camera.
1. Select [COMMUNICATION] option on the [SPECIAL]
menu.
2. Press [Open] or [Close] button.
3. Set the below options.
• PROTOCOL: This item lets you set a protocol for RS-
485 communication. Select the desired protocol.
• BAUDRATE: Select the desired speed of
communication between the system controller
and the camera. Confirm selected parameter to the
baud rate of the system controller.
• SAVE & EXIT: Select this option and then
press [Open] or [Close] button to save the
communication settings and exit the setting menu.