LG JBNQ18GB2A1, Owner'S Manual

Page: 34 / 48

Choose the connecting type as indicated Case 1 and Case2. In
Case 2, connect the cable through the knock-out hole on the
rear side of the bottom.
In Case 2, the diameter of the hole on the ceiling should be smaller
than 18mm to prevent it from being shown.
Connect the IR receiver cable to the CN-DISPLAY connector of
main PCB Assembly.
Fix the rear side of the installation board with the screw.
Check the mark Up & Down on bottom case inside.
When dissemble he IR receiver from the bottom case, use a
driver as shown in the picture and insert it into the hole as in-
dicated with the arrow mark. And when you pull the driver in the
front direction, the IR receiver will be separated.
15