DirectCD
TM
v2.5b(s)
Installation
7
Jumper Setup
Before installation, set the jumper connector on the rear panel.
The drive can be connected as the Master or Slave on an EIDE (ATAPI)
interface. When several (up to four) EIDE devices are connected, each
must be set in a unique way. Specific knowledge of hardware and
software is necessary to install the drive.
NOTE
: If two peripheral devices with the same settings are both
connected to the Primary or to the Secondary EIDE bus, the host
computer may fail to run or may malfunction. Careful attention is
necessary.
AUDIO O
UT
SELECT
IDE INT
ERFAC
E CON
NECTO
R
INPUT
DC
39
40
1
2
5V GN
D 12V
R GND L
C.SEL
SLAVE
MASTER
R GND L
C.SEL
SLAVE
MASTER
39
40
UDIO OUT
SELECT
CS: Cable Select (CSEL)
SL: Slave
MA: Master
NOTE :
Only one jumper should be installed on the jumper connector.
If more than one jumper is installed, the drive may malfunction or be
damaged.
Master/Slave setting is determined by jumper installation on the Jumper
Connector. The following table shows the possible jumper settings.
If you use CSEL setting, the MASTER/SLAVE setting will be made
automatically, depending on the hardware configuration.
For more details refer to the manual of your computer.
Name
Function
Drive set as Master
Drive set as Slave
Drive mode set by CSEL on the
host IDE interface
MA
(Master)
SL
(Slave)
CS
(Cable Select)
C
S
S
L
M
A
