4. FAN AND FAN MOTOR
1. Remove freezer drawers.
2. Remove two cap, screws and loosen two screws in
Grille Fan.
3. Pull out the Grille Fan and Shroud, F.
4. Disconnect the housing of lead wire.
5. Separate the Fan Assembly.
6. Losse 2 screw fixed to the Bracket.
7. Pull out Shroud, F remove the Fan Motor Assembly.
8. Separate the Motor Bracket and Rubber.
5. DEFROST CONTROL ASSEMBLY
Defrost Control Assembly consists of Thermistor and Fuse,
Melting. Thermistor functions to defrost automatically and it
is attached to metal side of the Evaporator and senses
temperature.
Fuse, Melting is a kind of safety device for preventing
overheating of the Heater when defrosting.
At the temperature of 77°C, it stops the emission of heat
from the Heater.
1
.
Pull out the Shroud, F after removing the Grille.
2
.
Separate the connector connected with the Defrost Control
Assembly and replace new one.
Thermister
Fuse, Melting
6. HEATER, SHEATH
In this refrigerator, Heater, Sheath is used for defrosting
heater. During heating, the temperature of heater rises
about 300 ~ 350 . Therefore, be careful not to burn while
servicing.
1
.
After removing the Grille and Shroud, separate the
Heater, Sheath by disconnecting the connectors.
2
.
Exchanged Heater, Sheath and connected the housing.
Heater, Sheath
3. REFRIGERATOR ROOM LED LAMP
1. Unplug the power cord from the outlet.
2. Assemble in reverse order of disassembly. Replacement must be
the same specification as original.
3. Remove the Cover Lamp, R by pulling with a '–' type driver.
4. Pull the latch to take out LED Lamp.
5. Remove the LED lamp by unplugin connect.
9
DISASSEMBLY
Summary of Contents for GC-B379S*CA
Page 12: ...12 CIRCUIT DIAGRAM P No MEZ62581565 ...
Page 38: ......
