LG GC-B379S*CA, Service Manual

Page: 8 / 38

NOTE
Reversing the doors is not covered by the warranty
1. DOOR
• Freezer Door
1. Refer to previous chapter "Instruction
for Reversing Door Swing".
2. Pull out the Door Gasket to remove from
the Door Foam Assembly, F.
GASKET
• Refrigerator Door
1. Refer to previous chapter "Instruction for Reversing
Door Swing".
2 . Pull out the Door Gasket to remove from the
Door Foam Assembly, R.
2. DOOR SWITCH
1. Unplug the power cor d from the outlet .
2 . L oosen fi ve screws in upper part and disconnect T op
C over Front .
3 . Disconnect L ead W ire from switch.
4 . Disengage hook behind the
switch by pressing it
with hands.
17
15
16
27
26
B
20
19
18
25
24
21v
23
16
19
20
15
B
29
3
2
28 5
6
6. Unscrew bolts (15) of the middle hinge (16), rise up the
freezer door (B) to remove it. Take off cap cover (17) and
install it instead of middle hinge (16).
Unscrew bolts (18) of lower hinge (19) rotating it by opposite
of clockwise and than screw it in opposite side hole.
Unscrew the bolts (20), which is fixing lower hinge (19) &
bolt (21) on the case of the refrigerator. Unscrew the screw
(22)on the bottom of the case which is fixated closer (23) of
the freezer door (B) , move closer (23) to the opposite side
in appropriated place and fix it up.
Unscrew the screw (24)on the bottom of the case which is
fixated emphasis (25) of the freezer door (B) , move
emphasis (25) to the opposite side in appropriated place
and fix it up.
Move the upper cap (26) on the opposite side.
7. Attach removed lower hinge (19) to the hole, located on
the opposite side of the case and tighten it by screws (20).
Screw in bolt (21) in the case of the refrigerator on
the opposite side. Install freezer door (B) to the pin in the
lower hinge (19). Turn over removed middle hinge (16) axis
outwards, and tighten it by screws (15) (Tight carefully to
prevent scratching of the door). Install the washer (27) on
the middle hinge (16).
22
8. Install the refrigerator door (A) through matching holes
in the lower of the door and pin of the middle hinge (16).
Then install the upper hinge (28), supplied with
refrigerator by placing in the appropriated hole of the
refrigerator door (A). Connect the connector cable (5)
(only for exterior display type models). Fix the upper hinge
(28) by bolts (3). Install cover upper hinge (29) and
tighten it by screw (2). Input the cover (6) which is
supplied with refrigerator.
INS T RUCTIONS FOR R E VERSING DOOR SWING
8
DISASSEMB LY