32
Test 5
Door switch test
Caution
Trouble Symptom
Measurement Condition
Before measuring resistance, be sure to turn Power off, and do voltage discharge.
(When discharging, contact the metal plug of Power cord with earth line.)
Door Opening is not sensed.(During operation, when opening Door, Drum motor and
Heater run continuously) Door Close is not sensed.
(Drum motor will not operate. Display will flash at 0.5 second intervals.)
After turning Dryer Power Off, measure resistance.
Check Controller.
Check Harness-linking connector.
NO
YES
• Door switch
Check (Refer to
Component
testing.)
YES
NO
• Check Lamp.
(When opening
Lamp, replace then
measure again.)
• Door switch
Check(Refer to
Component
testing.)
NO
YES
1
1
2
BK2
BL2
• Door switch
Check (Refer to
Component
testing.)
YES
NO
• Door switch
Check (Refer to
Component
testing.)
BL2
WH4
Measure while Door is closed. Check it resistance is
below 2500
Ω
between BL2-
(White wire) and
BK2-
Connector
BL2 ,WH4 after taking BL2,WH4 out from Controller.
Measure while Door is open. Check it resistance is
300~60
Ω
between BL2-
(White wire) and BK2-
(Black wire). Connector BL2,WH4 after taking
BL2,WH4 out from Controller.
Measure while Door is open. Check it resistance is
below 1
Ω
between WH4-
(Yellow wire) and
BL2-
(White wire) after taking Connector BL2,WH4
out from Controller.
Measure while Door is closed. Check it resistance is
below 1
Ω
between WH4-
(Yellow wire) and
BL2-
(White wire) after taking Connector BL2,WH4
out from Controller.
Summary of Contents for DLEX0001TM
Page 2: ...November 2007 PRINTED IN KOREA P No 3828EL3005P ...
Page 20: ...19 WIRING DIAGRAM 8 ELECTRIC DRYER WIRING DIAGRAM GAS DRYER WIRING DIAGRAM ...
Page 41: ...40 1 Pull ou the drawer PANEL DRAWER ASSEMBLY 2 Unscrew one screw 3 Lift out the Steam feeder ...
Page 49: ...48 EXPLODED VIEW 14 14 1 Control Panel Plate Assembly A210 A211 A140 A110 A120 A130 ...