LG Dishwasher, Installation Manual

Page: 13 / 40

ENGLISH
INSTALLATION INSTRUCTIONS 13
STEP 11: WATER SUPPLY CONNECTION
STEP 12: ELECTRICAL POWER CONNECTION
STEP 13: FINAL CHECK
1. Turn on electrical power.
2. Turn on house water supply.
3. Run the dishwasher on a normal cycle to verify proper operation and check for leaks.
4. Replace the toekick panel.
If during the final check of the dishwasher an error code appears, reference the chart below before calling for service.
Codes: “OE”
#1 It may be due to a kinked or pinched drain hose. To avoid this issue be sure to pull on the drain hose while you
slide the dishwasher into place not allowing any slack behind the dishwasher.
#2 The dishwasher drain hose was connected to a disposal. Verify that the knockout on the disposal has been
removed.
Codes: “IE”
#1 Check to make sure the water supply line to the dishwasher has been turned on.
#2 Check to make sure that the water supply line is not kinked under the dishwasher.
NOTE
1. Before connecting, turn off the water supply.
2. After fitting the elbow into the inlet valve, slide the
flexible stainless-steel water line or copper tube into
the elbow.
3. Tighten the compression nut and make sure that the
line is not kinked or pinched.
While testing the dishwasher, after the installation is
complete, an IE code appears on the display. It may
be due to a kinked water line or water supply to the
dishwasher has been turned on. Check this before
calling for service.
NOTE
Water
supply
line
Elbow
Junction box cover
Junction box
FIG. 16
FIG. 17
1. Before beginning, turn off electrical power to the
unit at the circuit breaker.
2. Remove the junction box cover and then install the
strain relief.
3. Twist wire connectors tightly onto the wires; then
wrap each connection with electrical tape.
4. Check again and make sure that all wires are con-
nected correctly: black to black, white to white,
green ground wire to green ground wire.
5. Replace the junction box cover.
Verify that the black wire is hot (120V). If not, or if
you are unsure of the power supply, have it checked
by a licensed electrician.
CAUTION