LGE Internal Use Only
Copyright © 2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
3. TECHNICAL BRIEF
- 31 -
3.5.4 VCTCXO
The Voltage Controlled Temperature Compensated Crystal Oscillator (VCTCXO) provides the reference
frequency for all RFIC synthesizers as well as clock generation functions within the MSM6280 IC. The
oscillator frequency is controlled by the MSM6280 IC.s TRK_LO_ADJ pulse density modulated signal in the
same manner as the transmit gain control TX_AGC_ADJ. A two-pole RC lowpass filter is recommended on
this control line.
The PM6650 IC controls the handset power-up sequence, including a special VCTCXO warm-up interval
before other circuits are turned on. This warm-up interval (as well as other TCXO controller functions) is
enabled by the MSM TCXO_EN line . The PM6650 IC VREG_TCXO regulated output voltage is used to
power the VCTCXO and is enabled before most other regulated outputs.
Any GSM mode power control circuits within the MSM6280 IC require a reference voltage for proper
operation and sufficient accuracy. Connecting the PM6650 IC REF_OUT directly to the MSM6275 IC
GSM_PA_PWR_CTL_REF provides this reference. This sensitive analog signal needs a 0.1 µF low
frequency filter near to MSM side, and isolate from digital logic and clock traces with ground on both sides,
plus ground above and below if routed on internal layers
3.5.5 PMIC Functional Block Diagram
• Input power management
- Valid external supply attachment and removal detection
- Supports unregulated (closed-loop) external charger supplies and USB supplies as input power
sources
- Supports lithium-ion main batteries
- Trickle, constant current, constant voltage, and pulsed charging of the main battery
- Supports coin cell backup battery (including charging)
- Battery voltage detectors with programmable thresholds
- VDD collapse protection
- Charger current regulation and real-time monitoring for over-current protection
- Charger transistor protection by power limit control
- Control drivers for two external pass transistors and one external battery MOSFET-MOSFET is
optional
- Voltage, current, and power control loops
-Automated recovery from sudden momentary power loss
• Output voltage regulation
- One boost (step-up) switched-mode power supply (SMPS) for driving white LEDs and hosting
USBOTG
- Three buck (step-down) switched-mode power supplies that efficiently generate MSMC, MSME, and
PA (or second MSMC) supply voltages
- Supports dynamic voltage scaling (DVS) for MSMC and PA
- Eleven low dropout regulator circuits with programmable output voltages, implemented using three
different current ratings: 300 mA (two), 150 mA (six), and 50 mA (three). These can be used to
power MSMA, MSMP, RFRX1, RFRX2, RFTX, SYNT, TCXO, WLAN, MMC, USB, and RUIM
circuits.
Z3X-BOX.COM
Summary of Contents for CU720 Black
Page 203: ...Note Z 3 X B O X C O M ...
Page 204: ...Note Z 3 X B O X C O M ...