9
PWR
POWER
12V
Service Port
Feature Port Control Port
RF-OUT
ASI-OUT
RF-OUT
0 dBmV
FIRMWARE VER:
Rx.x
MAC ADDRESS:
<Eth0>
xx:xx:xx:xx:xx:xx
<Eth1>
xx:xx:xx:xx:xx:xx
MODEL: PCS200R DATE: xx/xx/xx
I IIIII IIIIIIII IIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIII
*201-1252008*
SSD (OPTIONAL)
MAXIMUM CURRENT
+5V DC @ 2.0A
PWR
POWER
12V
Service Port
Feature Port Control Port
RF-OUT
ASI-OUT
RF-OUT
0 dBmV
FIRMWARE VER:
Rx.x
MAC ADDRESS:
<Eth0>
xx:xx:xx:xx:xx:xx
<Eth1>
xx:xx:xx:xx:xx:xx
MODEL: PCS200R DATE: xx/xx/xx
I IIIII IIIIIIII IIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIII
*201-1252008*
SSD (OPTIONAL)
MAXIMUM CURRENT
+5V DC @ 2.0A
Rack Installation
Typical Rack Installation
1. (Optional) As shipped, the PCS200R
mounting brackets are attached flush with the front of
the unit (see diagram a). If desired, the mounting brackets may be detached from the unit
and reattached, for example, so that they are flush with the rear of the unit (see diagram
b). If you wish to change the location/orientation of the mounting brackets, carefully remove
each of the four (M4 x 10 mm) screws and attendant washers (one flat and one lock washer
per screw) holding each bracket in place. Then, use the same screws and washers to reat-
tach the mounting brackets in the desired location.
2. Carefully slide the chassis into a standard 19-inch equipment rack.
3. Use all four mounting screws to secure the chassis to the rack.
To rack
Use flat washer and
lock washer with each
M4 x 10 mm mounting
bracket screw.
To rack
(a)
(b)
Summary of Contents for Centric PCS200R Pro
