- 23 -
LGE Internal Use Only
Copyright ©
LG Electronics. Inc. All rights reserved.
Only for training and service purposes
5.4. Local Dimming Function Check
Step 1) Turn on TV
Step 2) At the Local Dimming mode, module Edge Backlight
moving right to left
Back light of IOP module moving
Step 3) confirm the Local Dimming mode
Step 4) Press “exit” Key
5.5. Magic Motion Remocon test
5.5.1. Test equipment
- RF-remote controller for check, IR-KEY-CODE remote
controller.
- Check AA battery before test. A recommendation is that a
tester change battery every lots.
5.5.2. Test
(1) Make pairing with TV set by pressing “Start key(Wheel
key)” on RCU.
(2) Check a cursor on screen by pressing ‘Wheel key” of RCU
(3) Stop paring with TV set by pressing “Back+ Smart” key of
RCU.
5.6. 3D function test
(Pattern Generator MSHG-600, MSPG-6100 [SUPPORT
HDMI1.4])
* HDMI mode NO. 872 , pattern No.83
1) Please input 3D test pattern like below (HDMI mode NO.
872 , pattern No.83)
2) When 3D OSD appear automatically , then select green
button
3) Don’t wear a 3D Glasses, Check the picture like below
5.7. Color Sensor Function Inspection
This Inspection is available only Power-Only Status.
(1) Turn on TV
(2) Press EYE key of Adj. R/C
(3) Confirm color sensor raw data for each channel
(4) Cover the Color sensor on the front of the using your hand
and wait for 6 seconds
(5) Confirm that value is lower than 10 of the
“Raw Data (Sensor data, Backlight )” and “OK” message.
If after 6 seconds, value is not lower than 10
and not showing the “OK” message, replace color sensor.
(6) Remove your hand from the color sensor and wait for 6
seconds
(7) Compare step 3) raw data.
If the variation is higher than 30 for each channel, replace
color sensor
Summary of Contents for AUSYLJR
Page 64: ......
