LG 65WU960H, Easy Setup Manual

Page: 24 / 65

ENGLISH
8
•
When installing the wall mount, check the positions
of the wooden studs using a stud finder. Then, fasten
the screws on at least two separate studs before
proceeding.
Stud Wall mount
• When installing the product on wall material not
designated, install the product so that each location
can withstand the pull out load of 70 kgf (686 N) and
shear load of 100 kgf (980 N) or above.
•
Use the Ø 8 mm (0.3 inches) drill bit for concrete and
hammer (Impact) drill.
Tools you will need
• Phillips head + driver (manual or motorized) / Ø 8
mm (0.3 inches) Drill bit / Level / Stud finder / Drill
How to attach to masonry walls
Please follow the below direction.
1
Use a drill bit Ø 8 mm (0.3 inches) to drill a hole
for the anchor location within a depth of 80 mm
(3.1 inches) to 100 mm (3.9 inches).
2
Clean the drilled hole.
3
Insert the sealed wall mounting anchor to the
hole. (When inserting the anchor, use a hammer.)
Wall mounting
anchor
4
Set the wall mount on the wall by aligning to the
location of the hole. And, set the angle adjusting
part to face upward.
5
Align the wall mounting screw to the hole and
tighten it. Then, fasten the screws at torque of 45
kgf/cm (39.06 lbf/in) to 60 kgf/cm (52.08 lbf/in).
Wall mounting
screw