12 PLASMA TV
Installation
Connecting PC
- To enjoy vivid picture and sound, connect a PC to the set.
- Avoid keeping a fixed image on the set’s screen for a long period of time. The fixed image may become permanently imprinted on
the screen; use a screen saver when possible.
- Connect PC to the RGB INPUT(PC INPUT) or HDMI INPUT(DIGITAL RGB INPUT) port of the set; change the resolution output
of PC accordingly.
- There might be noise according to some resolution, vertical pattern, contrast or brightness in PC mode. Change the PC mode into
another resolution or change the refresh rate into another rate or adjust the brightness and contrast on the menu until the picture
is clean. If the refresh rate of the PC graphic card can not be changed, change the PC graphic card or consult it to the manufac-
turer of the PC graphic card.
- The synchronization input waveform for Horizontal and Vertical frequencies are separate.
Setup Instructions to Connect a PC to your set
- We recommend using 1024x768, 60Hz for the PC mode, they provide the best picture quality.
In 42PX4RV series, we recommend using 640x480, 60Hz for the PC mode, they provide the best picture quality.
- If the resolution of PC is over UXGA, there will be no picture on the set.
- Connect the signal cable from the monitor output port of the PC to the RGB INPUT port of the set or the signal cable from the
HDMI output port of the PC to the HDMI INPUT port on the set.
- Connect the audio cable from the PC to the Audio input on the set. (Audio cables are not included with the set).
- If using a sound card, adjust PC sound as required.
- This set uses a VESA Plug and Play Solution. The set provides EDID data to the PC system with a DDC protocol. The PC adjusts
automatically to use this set.
- DDC protocol is preset for RGB (Analog RGB), HDMI (Digital RGB) mode.
- If required, adjust the settings for Plug and Play functionally.
- If graphics card on the PC does not output analog and digital RGB simultaneously, connect only one of RGB INPUT or HDMI
INPUT to display the PC on the set.
If graphic card on the PC does output analog and digital RGB simultaneously, set the set to either RGB or HDMI ; (the other mode
is set to Plug and Play automatically by the set.)
- DOS mode may not work depending on video card if you use a HDMI to DVI cable.
- When you use too long RGB-PC cable, there might be a noise on the screen. We recommend using under 5m of the cable. It pro-
vides the best picture quality.
PC Setup
1.
Turn on the PC and apply power to the set.
2.
Turn on the display by pressing the POWER button on
the set’s remote control.
3.
Use the INPUT or MULTIMEDIA button on the remote
control to select the
RGB
or
HDMI
input source.
4.
Set the resolution output of the PC to SXGA or under
(1280 x 1024, 60Hz). (Refer to p. 13)
External Equipment V
External Equipment V
iewing Setups
iewing Setups
AUDIO
AUDIO
L
R
VIDEO
VIDEO
COMPONENT
COMPONENT
AUDIO
AUDIO
L
R
V
VARIABLE
ARIABLE
AUDIO OUT
AUDIO OUT
AUDIO
AUDIO
(MONO)
(MONO)
L
R
S-VIDEO
S-VIDEO VIDEO
VIDEO
A
AV4
V4
A
AV1
V1
A
AV2
V2
A
AV3
V3
HDMI/
DVI(VIDEO)
AUDIO INPUT
RGB INPUT
RS-232C INPUT
(CONTROL/SERVICE)
REMOTE
CONTROL
< Back panel of the set >
Summary of Contents for 42PX4R
Page 47: ...Owner s Manual 47 Miscellaneous Notes Notes ...
Page 48: ...48 PLASMA TV Miscellaneous Notes Notes ...
Page 49: ...Owner s Manual 49 Miscellaneous Notes Notes ...
Page 52: ......