- 9 -
LGE Internal Use Only
Copyright ©
LG Electronics. Inc. All rights reserved.
Only for training and service purposes
4. ADC Process
4.1. ADC
- Set TV to YUV source by pushing"YUV)key
- Input full color bar signal using HD signal generator
* Required equipment : Factory remote control.
4.2. Function Check
4.2.1. Check display and sound
■ Check Input and Signal items.
(1) TV
(2) AV (CVBS)
(3) COMPONENT (1080I/480i)
(4) HDMI
* Display and Sound check is executed by Remote control.
<Caution> Not to push the "RESTORE" key after
completion if the function inspection.
EZ ADJUST
0
1. Tool Option2
2. Tool Option3
3. Tool Option4
4. Tool Option5
5. Tool Option Commercial
6. Country Group
7. Area Option
9. White Balance
10. 10 Point WB
11. Test Pattern
12. EDID D/L
13. Sub B/C
14. Ext. Input Adjust
ADC Calibration
ADC Comp 480i
ADC Comp 1080p
ADC Type
NG
NG
Reset
Begin adjust by pushing “ADC ADJ" key
HD signal generator.
100% color bar
Note: 1. The YPBPR Auto White Balance adjust
(AUTO ADC) must be done on the product line.
2 In YPBPR channel ,must adjust the SD
and HD two modes.
6. Click “Read” to load the main software for this TV set.
7. Click “Auto”to ready for HDCP Key updating. Settings
as below:
8. Click to select “Partial Erase”, then click Setup. An erase
block setting window will pop up. Choose the bank according
to
"0X390000"for 32LB520B/60LB5200/65LB5200
. Click
“OK”to confirm.
9. Click “Run” to update the HDCP Key.
Warm Tips:
The HDCP Key index value will be increased automatically.
That means after you update the first TV set, you only need
to connect another TV set to your PC, click “Connect”, then
“Run” to update.