LG SIGNATURE OLED65W7 Series, Safety And Reference

Page: 33 / 58

13
ENGLISH
•
Do not mount the device on the walls made
from plasterboard or medium density
fiberboard (MDF). In this case, the anchor and
screws must be inserted into the concrete
behind the finish surface. If there is no
concrete on the other side, then you must first
install a separate hanger to securely install the
anchors and screws.
•
When installing the product on wall material
not designated, install the product so that
each location can withstand the pull out load
of 70 kgf (686 N) and shear load of 100 kgf
(980 N) or above.
•
Use the Ø 8 mm drill bit for concrete and
hammer (Impact) drill.
Tools you will need
•
Phillips head + driver (manual or motorized),
Ø 3/6/8 mm Drill bit, Level, Stud finder, Drill
How to attach to masonry walls
Please follow the below direction.
1 Use a drill bit Ø 8 mm to drill a hole for the
anchor location within a depth of 80 mm to
100 mm.
2 Clean the drilled hole.
3 Insert the sealed wall mounting anchor to
the hole. (When inserting the anchor, use a
hammer.)
Wall mounting anchor
4 Set the wall mount on the wall by aligning
to the location of the hole. And, set the angle
adjusting part to face upward.
Wall mount
5 Align the wall mounting screw to the hole
and tighten it. Then, fasten the screws at
torque of 45 kgf/cm to 60 kgf/cm.
Wall mounting screw