LG-Nortel IP8840, User Manual

Page: 20 / 36

IP8840 Broadworks IP Phone
User Guide
15 Dec. ‘08
08:30
Ring Setting
>1.Default Ring Type
2.Line 1 Configuration
3.Line 2 Configuration
4.Line 3 Configuration
5.Line 4 Configuration
6.Line 5 Configuration
7.Line 6 Configuration
Previous Next OK
08:30
Default Ring Type (1)
>*Type 1
Type 2
Type 3
Type 4
Wave Ring 1
Wave Ring 2
Wave Ring 3
Play Next OK
08:30
Line 1 Configuration
>1.Ring Type
2.Delayed Ring Timer
Previous Next OK
type assigned for the IP Phone is the “Default Ring Type” for incoming calls to the phone and is set to
“ringer off” or one of the fourteen tones.
To set the ring type for the phone (Default Ring Type):
o
Press the Setting ( ) button.
o
Dial 3, or move the cursor to
3.Phone Settings
using the
Previous
-
Next
softkeys and press the
OK
softkey.
o
Dial 2, or move the cursor to
2.Ring Setting
using the
Previous
-
Next
softkeys and press the
OK
softkey.
o
Dial 1, or move the cursor to
1.Default Ring Type
using
the
Previous
-
Next
softkeys and press the
OK
softkey. An
asterisk,
»
, displays in front of the current setting.
o
Select the ring type using the
Next
softkey. Press the
Play
softkey to hear the selected tone.
o
Press the
OK
softkey to save the selected the ring type.
o
Move to another parameter with the navigation buttons and
continue the session or press the Setting ( ) button to
exit the configuration session.
5.2.2. Setting Line Ring Type and Delay
You can assign each line with a different ring type (tone) to distinguish which line is ringing. Selections
for the type include one of up to fourteen tones, “Ringer Off”, or “Set to Default”, see section 5.2.1 . Of
the fourteen tones, five are permanently stored in the memory of the phone and the remaining five must
be downloaded before use. In addition, for each line the ring signal can be immediate or delayed. The
delay is set in 1 second increments from 0 (no delay) to 10 seconds.
To set the ring type for a line:
o
Press the Setting ( ) button.
o
Dial 3, or move the cursor to
3.Phone Settings
using the
Previous
-
Next
softkeys and press the
OK
softkey.
o
Dial 2, or move the cursor to
2.Ring Setting
using the
Previous
-
Next
softkeys and press the
OK
softkey.
o
Dial the Line number plus one (2 for Line 1, 3 for Line 2,
etc.), or move the cursor to
Line
n Configuration
using
the
Previous
-
Next
softkeys and press the
OK
softkey.
The value of
n
is the Line button number.
o
Dial 1, or move the cursor to
1.Ring Type
using the
Previous
-
Next
softkeys and press the
OK
softkey. Note
the line number displays in parenthesis after “Ring Type”.