GA 01.299/7 - 03/99
2
Installation
2.1
Mounting AK 1.6 and AF 1.6
Remove inlet and/or outlet port connection, as required,
on top of pump body, undoing two each hex socket head
screws (Allen screws). The same connection are then
fitted on top of connected intake-side condensate trap or
exhaust-side filter. Mount trap and/or filter on the pump
by the counter flange at the underside of the connecting
yoke. The necessary O-ring and two additional Allen
screws are supplied with the trap and filter.
If the TRIVAC S/D 1.6 B pump is used with condensate
trap only, the lower part of the AK 1.6 may be turned
round to facilitate condensate-level-checking, un-
screwing the two Allen screws through the upper yoke.
The cooling ribs of the AK 1.6 are therby placed directly
opposite to those of the pump, while the inspection
window, together with the oil level indicator of the pump,
can be checked at a glance.
2.2
Mounting AK/AF 4-8, 16-25 and 40-65
The direction of flow is marked by an arrow
and must be observed when connecting
the filter.
As shown in Fig. 3, fit the exhaust filter or the separator
directly on the horizontally mounted flange of the
TRIVAC. For connection fittings refer to Section 1.2.
When aromatic vapors are pumped, we recommend
fitting an exhaust line even in case of optionally mounted
exhaust filters.
When toxic gases or vapors are pumped,
an exhaust line must be fitted in accor-
dance with the safety regulations relating to
protection against poisonous vapors.
19
Warning
Warning
GA 01.299/7 - 03/99
2
Installation
2.1
Mounting AK 1.6 and AF 1.6
Remove inlet and/or outlet port connection, as required,
on top of pump body, undoing two each hex socket head
screws (Allen screws). The same connection are then
fitted on top of connected intake-side condensate trap or
exhaust-side filter. Mount trap and/or filter on the pump
by the counter flange at the underside of the connecting
yoke. The necessary O-ring and two additional Allen
screws are supplied with the trap and filter.
If the TRIVAC S/D 1.6 B pump is used with condensate
trap only, the lower part of the AK 1.6 may be turned
round to facilitate condensate-level-checking, un-
screwing the two Allen screws through the upper yoke.
The cooling ribs of the AK 1.6 are therby placed directly
opposite to those of the pump, while the inspection
window, together with the oil level indicator of the pump,
can be checked at a glance.
2.2
Mounting AK/AF 4-8, 16-25 and 40-65
The direction of flow is marked by an arrow
and must be observed when connecting
the filter.
As shown in Fig. 3, fit the exhaust filter or the separator
directly on the horizontally mounted flange of the
TRIVAC. For connection fittings refer to Section 1.2.
When aromatic vapors are pumped, we recommend
fitting an exhaust line even in case of optionally mounted
exhaust filters.
When toxic gases or vapors are pumped,
an exhaust line must be fitted in accor-
dance with the safety regulations relating to
protection against poisonous vapors.
19
Warning
Warning
