Cleaning the air filter
NOTES ON MAINTENANCE
NOTE
The scooter is attached with a oil foam air
filter. In case of heavy dirtiness the foam(3)
has to be replaced.
- Remove the screws (1)and take off the air
filter cover (2).
- Remove the foam (3).
- Clean the foam with Motorrex air cleaner.
- Afterward soak and wring out the foam wi-
th air filter oil.
Disassembly and cleaning
Installation
- Clean the hole (4) before installation.
- Usually the installation takes place in rev-
erse order to disassembly.
CAUTION
Never run the engine without air filter.
- Dust depsit is one of the major causes of
reducing output horsepwer and increasing
fuel consumption.
- Change the air cleaner element more fre-
quently to prolong the engine
,
s service life
if the scooter is ride on dusty roads very
often.
- Check for properly installation of the foam
housing in the filter case.
- Otherwise the engine runs poorly or lead
to serious engine damage.
- Be careful not to soak the air cleaner wh-
en washing the scooter. Otherwise it will
cause engine hard to start.
32
1
1
1
1
1
1
2
4
3
The air inlet of oil-gas separator
connects
with cylinder breath pipe, air outlet connects
with air filter port, oil discharge outlet should
face to the ground. If there's too muchoil in
the oil discharge pipe, please release the oil
and check the oil measure tape if the engine
oil is enough.
(5)
5
