57 Configuration change, some held jobs were not restored
Something has changed in the printer to invalidate the held jobs. Possible changes include:
•
The printer firmware has been updated.
•
Paper input options needed for the print job were removed.
•
The print job was created using data from a device in the USB port and the device is no longer in the USB port.
•
The printer hard disk contains print jobs that were stored while installed in a different printer model.
Select
Continue
to clear the message. For non
‑
touch
‑
screen printer models, press
to confirm.
58 Input config error
1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Check if all tray configurations are correct. Remove unnecessary trays if needed.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
58 Too many disks installed
1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the excess disks.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
58 Too many flash options installed
Try one or more of the following:
•
Select
Continue
to clear the message. For non
‑
touch
‑
screen printer models, press
to confirm.
•
Remove extra flash options:
1
Turn off the printer.
2
Unplug the power cord from the wall outlet.
3
Remove the excess flash memory.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Troubleshooting
225
