Lexmark 4039-1XX, Service Manual

Page: 86 / 196

70
Service Manual
Drive Motor Removal
1. Unplug the power cord.
2. Remove the system board.
3. Remove the system board inner EMC shield.
4. Remove the fuser input guide [A].
5. Remove the transfer housing assembly.
6. Remove the gear cover by releasing the rear latch and lifting up.
7. Remove screw [C] and the grounding clip (this clip is not present
on all machines).
8. Remove the motor mounting nuts [B] and screws.
9. Work the motor out of the machine.
10P: Do not remove the motor from the gear bracket assembly; they
are not available separately.
Installing the motor: If the motor has been removed from the gear
bracket assembly, you must use the gear retaining plate as a tem-
plate to be sure the motor pinion is correctly positioned to gear 4.
Install the gear retaining plate to the gear bracket assembly and
tighten the nuts. Install the motor to the assembly and tighten the
screws. Remove the gear retaining plate from the assembly and
install the motor in the printer.