Lexmark 13P0195 - C 750dn Color Laser Printer, Service Manual

Page: 66 / 490

2-32
Service Manual
5060-00 x
Reattach Output Bin x
Reattach Bins x - y
Check Tray x
Connection
These messages are displayed anytime the printer loses
communications with one of the following options:
• Output Bin x ( x =1, 2, or 3)
• Bins ( x - y =1 through 5)
• Tray x ( x =2, 3, 4, or 5)
• Duplex
• Finisher
Check Duplex
Connection
Check Finisher
Connection The specified option could have been removed from the
printer, maybe to clear a paper jam or to uninstall the option
or the option may be still installed but experiencing a
communications problem. The option may not be fully
installed or it may have a hardware failure. The most likely
cause of this message is a failure to reattach the option
when removed to service a printer intervention.
If the option was temporarily removed or not connected
properly, then reattach or reconnect it. When the option is
recognized, the printer automatically clears the attendance
message and continues. Press
Go to execute a
configuration change which will tell the printer the option has
been Hot Unplugged removed. In this case it is assumed
that the user wants to continue to operate the printer with
the option removed. If the problem continues, turn the
printer off and back on. If the message continues to be
displayed, turn the printer off, remove the option and call for
service.
Close Door This message is displayed when the printer upper front
cover (door) is open.
Close the upper front cover (door).
Close Finisher Door This message is displayed when the finisher Option top
cover is open. Close the finisher top cover.
Disk Corrupted This message is displayed when the printer has detected
that there are errors on the hard disk that could not be
corrected. The disk cannot be used until it has been
reformatted.
The following actions can be taken:
• Press Return or Stop to clear the message.
The disk cannot be used without reformatting the
disk.
Note : All data will be lost for the following action:
• Press Go to format the disk.
Hole Punch Waste
Full This message is displayed when the Hole Punch Alarm is on
and the code has determined that the hole punch waste box
is full.
The following actions may be taken while this message is
displayed:
• The user may empty the hole punch box and put it back
to clear the message.
• Press Go to ignore the message and the job prints
without hole punching.
Each time a new job requests hole punch and the box is not
emptied, this message is displayed.
User primary
message User secondary
message
Explanation