Lexicon M300L, Owner'S Manual

Page: 49 / 162

Lexicon
300L Owner's Manual
3-20
-24 18 12 6 0 6 +12 ovld dB
L
R
Note
The following store procedures apply
only to effect Registers. Once you have
modified and stored these effects, you must store them into a Setup Register.
To do this, press SETUP, then press STOre. The upper display will show:
AVAILABLE
DM: SET R 1
Press STOre again. The message "STORED" will be displayed briefly to indicate
that a successful store operation was completed.
If you have modified the effect(s) running in the Setup and wish to skip storing
the effect or effects into specific Effect Registers, simply press the SETUP key
to return to the top level and press STOre. Select a Setup Register with the REG
slider, then press STOre again. The 300L will automatically store the modified
Effect into an available register, and then complete the Setup store. This process
will take approximately 2 seconds. The newly stored effect will be found with its
original name, truncated to allow the Setup Register ID number to be added at
the end as an identifier. See the example below.
LARGE H @SA 1
300MA: B01P1
If both effects in a split Setup have been modified, two effect registers will be
created, each with a machine identifier (A or B). Both effect registers will indicate
the same Setup register location, as shown in the example below.
-24 18 12 6 0 6 +12 ovld dB
L
R
-24 18 12 6 0 6 +12 ovld dB
L
R
S=Setup
A=Machine A
1=Setup Register 1
REV/RE @SA 1
300MA: B01R2
-24 18 12 6 0 6 +12 ovld dB
L
R
REV/RE @SB 1
300MA: B01R3
Both effect names now reference Setup Register 1
the first 7 characters of the
original program name
Automatic Storing of
Modified Effects